TECHNICAL REFERENCE MANUAL Dyvi 2.0.7.2
Supervisor 63
Note
• To ensure better compatibility, productions using Ember+
protocol should be created from scratch using integrated
“New production” tool.
• Default Ember+ port = 9000.
• LAWO/VSM SW version shall be minimum v2111.
Low Res. Scale
A low-resolution copy of every input is created for the multiviewer. This
menu allows you to define the size of the low-resolution picture. Available
resolutions are:
• 640×360
• 480×270
• 320×180
Reducing the size of Low Res. Scale might be an effective way of fitting
data to 10Gbit network Error! Reference source not found.topology.
Note
• The Low Res. Scale setting must be identical for all
Processing Modules contributing to a Production Cluster
(those which have the same Cluster-ID).
Low Latency Mode
o Low Latency Mode is a solution for 1 PM productions running in
interlaced mode 1080i50 or 1080i59.94.
When Low Latency mode is on, the system has a delay of 3 fields. SDI
outputs are operating at fastest rate and are “fields-swapped” compared to
reference.
When Low Latency mode is off, the system has a delay of 4 fields. SDI
outputs are in sync with reference.
To Next Page
Loading...
