Accessing Your Unit Remotely
206 FTB-2/FTB-2 Pro and FTB-4 Pro
Working with Remote Desktop
To access your unit remotely with Remote Desktop:
1. Connect both the computer and your unit to the same network and
make sure they can “see” each other as network restrictions might
prevent them from communicating.
If you want to use an Ethernet network, connect an RJ-45
(network) cable to the unit’s Ethernet (RJ-45) port located on its
right panel.
If you want to use a wireless network, see Connecting to a Wireless
Network on page 178.
2. Turn on both the computer and the unit.
3. On your unit, from Toolbox X, tap the button (located at the bottom
of the button bar).
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
