EXFO FTB-2 - Page 239

Testing Network Connections
FTB-2/FTB-2 Pro and FTB-4 Pro 229
Performing a Ping Test
4. Enter a URL or an IP address to reach. You can tap the Default button
to use the unit's default ping address. The default value cannot be
configured.
5. Set the other parameters:
 Number of packets to send
 Packet size
 Timeout limit
 TTL limit
 Clear the Allow fragmentation check box if you prefer sending
complete packets to the host.
6. Tap the Start button.
You can stop a ping test at any time by tapping the Stop button.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com