Preparing for Automation
272 FTB-2/FTB-2 Pro and FTB-4 Pro
Configuring Your Instruments
4. From the LINS offset value list, select a value that will be used when
assigning the LINS that will help you identify the instruments more
easily if you are working with several units housing modules.
If you prefer to access the instruments using the LINS as is, leave the
offset value to 0.
Note: The LINS offset value that you select applies only to the unit on which you
configure the parameters.
Note: The LINS offset value that you select will be used to build the LINS of the
next instruments that you will insert in the unit. The LINS of the instruments
that were already in the system when you selected the LINS offset value
will not be updated.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
