Communicating Through TCP/IP Over Telnet
486 FTB-2/FTB-2 Pro and FTB-4 Pro
Internal Commands of the TCP/IP over Telnet Protocol
Notes To know the status of the modules before
terminating connections using the KILL LINS
command, you can first enter the STATUS CLIENT
command. For more information, see STATUS
CLIENT on page 487.
In the example below, two modules are connected:
LINS13 and LINS10.
To disconnect the LINS10 module used by
another session, enter the kill lins10 command. A
confirmation message is displayed once the
module is disconnected.
Enter again the STATUS CLIENT command to
confirm the termination of the module (LINS10 in
our example). Only the information of the
remaining connected client is displayed.
KILL LINS
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
