Test Setup - Test Configurator, Timer, and System
176 FTB-700G/800 Series
MAC/IP/UDP
OUI, available when the frame format 802.3 SNAP is selected, allows
the selection of the Organizationally Unique Identifier (OUI):
RFC1042 (0x000000) - (default)
User Defined, available when Network Layer is set to None, allows to
enter the OUI value: 0x000000 (default) to 0xFFFFFF.
Note: Source/Destination Flooding and Flood Range are only available with
Traffic Gen & Mon when the Network Layer is set to None (see page 173).
Source Flooding and Destination Flooding check boxes when
selected (cleared by default) allows generation of frames using
source/destination MAC addresses flooding as follows: The first frame
is transmitted starting with the least significant bits of the
source/destination MAC address covered by the range set to 0; each
subsequent frame is transmitted by incrementing the least significant
bits by 1; when the upper limit of the range is reached, the
source/destination MAC address restarts over with the least significant
bits covered by the range set to 0.
Flood Range is the range of the least significant bits used for the
Source Flooding and/or Destination Flooding: 2(1bit), 4(2bits),
8(3bits), 16 (4 bits)... up to 16777216 (24 bits) (default).
VLAN
Note: VLAN is only available when the VLAN Tag is enabled; refer to Modify
Frame Structure on page 173.
For each VLAN tag enabled, C-VLAN / S-VLAN / E-VLAN, the following
parameters are configurable.
VLAN ID choices are 0 through 4095; refer to VLAN ID and Priority on
page 639 for more information.
Priority, VLAN user priority, choices are 0 (default) to 7. Refer to VLAN
ID and Priority on page 639 for more information.
To Next Page
Loading...
