S
UMMIT
S
WITCH
I
NSTALLATION
AND
U
SER
G
UIDE
8-9
C
ONFIGURING
Q
O
S
S
AMPLE
I
NGRESS
M
ODE
Q
O
S C
ONFIGURATION
The following ingress mode example modifies an existing QoS profile and applies it to a
VLAN traffic grouping. The priority parameter, although required, is ignored when
configuring a default QoS profile in ingress mode.
config qosprofile qp4 minbw 15% maxbw 100% priority high
config vlan sales qosprofile qp4
S
AMPLE
E
GRESS
M
ODE
Q
O
S C
ONFIGURATION
This egress mode example does the following:
• Configures the QoS mode and devicemode of the switch.
• Creates a QoS profile mktgqos, with the following characteristics:
— minimum bandwidth = 0%
— maximum bandwidth = 10%
— priority = low
• Applies the QoS profile mktgqos to a range of IP addresses.
The steps to configure this example are as follows:
1 Configure the switch for the egress mode, by typing the following:
config qosmode egress
2 Reboot the switch.
3 Configure the switch for the correct devicemode, by typing the following:
config devicemode ipqos
4 Reboot the switch.
5 Create and configure the QoS profile mktgqos,, by typing the following:
create qosprofile mktgqos
config qosprofile mktgqos minbw 0% maxbw 10% priority low
6 Apply the QoS profile to a range of IP addresses, by typing the following:
config ipqos add 128.1.0.0/16 qosprofile mktgqos
Summit.bk : 8QOS.FM Page 9 Thursday, June 18, 1998 9:27 AM
To Next Page
Loading...
