Extreme Networks Summit1 - Port-Mirroring Commands; Port-Mirroring Example; Port-Mirroring Configuration Commands

S
UMMIT
S
WITCH
I
NSTALLATION AND
U
SER
G
UIDE
4-9
P
ORT
-M
IRRORING
P
ORT
-M
IRRORING
C
OMMANDS
Port-mirroring commands are described in Table 4-7.
P
ORT
-M
IRRORING
E
XAMPLE
The following example selects port 3 as the mirror port, and sends all traffic coming
into or out of the switch on port 1 to the mirror port:
enable mirroring port 3
config mirroring add port 1
The following example sends all traffic coming into or out of the switch on port 1 and
the VLAN default to the mirror port:
config mirroring add port 1 vlan default
Table 4-7:
Port-Mirroring Configuration Commands
Command Description
enable mirroring port <port> Dedicates a port on the switch to be the mirror port.
config mirroring add [mac <mac_address>
| vlan <name> | port <port> | vlan
<name> port <port>]
Adds a single mirroring filter definition. Up to eight
mirroring definitions can be added. You can mirror
traffic from a MAC address, a VLAN, a physical
port, or a specific VLAN/port combination.
config mirroring delete [mac
<mac_address> | vlan <name> | port
<port> | vlan <name> port <port> | all}
Deletes a particular mirroring filter definition, or all
mirroring filter definitions.
disable mirroring Disables port-mirroring.
show mirroring Displays the port-mirroring configuration.
Summit.bk : 4PORTS.FM Page 9 Thursday, June 18, 1998 9:27 AM