Extreme Networks Summit1 User Manual

3-20 S
UMMIT
S
WITCH
I
NSTALLATION AND
U
SER
G
UIDE
A
CCESSING
T
HE
S
WITCH
Ta b le 3 - 7 describes SNMP configuration commands.
Table 3-7:
SNMP Configuration Commands
Command Description
enable snmp access Turns on SNMP support for the switch.
enable snmp trap Turns on SNMP trap support.
config snmp add <ipaddress> {<mask>} Adds the IP address of an SNMP
management station to the access list. Up
to 32 addresses can be specified.
config snmp add trapreceiver <ipaddress>
community <string>
Adds the IP address of a specified trap
receiver. The IP address can be a
unicast, multicast, or broadcast. A
maximum of 6 trap receivers is allowed.
config snmp add community [read | readwrite]
<string>
Adds an SNMP read and write community
string. Each community string can have a
maximum of 127 characters.
config snmp delete [<ipaddress> {<mask>} | all] Deletes the IP address of a specified
SNMP management station or all SNMP
management stations. If you delete all
addresses, any machine can have SNMP
management access to the switch.
config snmp delete trapreceiver [<ip_address>
community <string> | all]
Deletes the IP address of a specified trap
receiver or all authorized trap receivers.
config snmp delete community [read | readwrite]
<string>
Deletes an SNMP community string.
config snmp syscontact <string> Configures the name of the system
contact. A maximum of 255 characters is
allowed.
config snmp sysname <string> Configures the name of the switch. A
maximum of 255 characters is allowed.
The default sysname is the model name of
the Summit, such as
Summit1
,
Summit2
,
Summit3
, and so on. The sysname
appears in the Summit prompt.
config snmp syslocation <string> Configures the location of the switch. A
maximum of 255 characters is allowed.
Summit.bk : 3MGMT.FM Page 20 Thursday, June 18, 1998 9:27 AM

Extreme Networks Summit1 Specifications

General

Brand	Extreme Networks
Model	Summit1
Category	Switch
Language	English