S
UMMIT
S
WITCH
I
NSTALLATION
AND
U
SER
G
UIDE
3-15
U
SING
T
ELNET
8 When you are finished using the facility, log out of the switch by typing
logout
D
ISCONNECTING
A
T
ELNET
S
ESSION
The administrator-level account can disconnect a management session that has been
established by way of a Telnet connection. If this happens, the user logged in by way of
the Telnet connection is notified that the session has been terminated.
To terminate a Telnet session, follow these steps:
1 Log in to the switch with administrator privileges.
2 Determine the session number of the session you want to terminate by typing
show session
Sample output from the
show session
command is as follows:
show session:
0 Wed Sep 17 20:48:38 1997 admin console serial
4 Wed Sep 17 21:52:16 1997 admin telnet 192.208.37.26
3 Terminate the session by using the following command:
clear session <session_number>
D
ISABLING
T
ELNET
A
CCESS
By default, Telnet services are enabled on the switch. You can choose to disable Telnet
by entering
disable telnet
To re-enable Telnet on the switch, at the console port enter
enable telnet
You must be logged in as an administrator to enable or disable Telnet.
Summit.bk : 3MGMT.FM Page 15 Thursday, June 18, 1998 9:27 AM
To Next Page
Loading...
