Software- and Web Page-based Setup and Control, cont’d
4-28
PRELIMINARY
MLC 226 Series • Software-and Web Page-based Setup and Control
This dialog box overlays the device images and obscures them, but you can
click and drag the box to move it around within the configuration program
window to uncover control modules, the remote control, and other items.
2. Select the type of operation to be performed:
• Driver Operations — executes a command from one of the device
drivers selected in the RS-232/IR Config. tab.
• Relays/Internal Operations — causes a specific relay (1-6) to turn on,
turn off, toggle, or pulse; or you can set digital output operations,
configure button lights, or delays between commands.
• User-defined RS-232 Operations — executes an RS-232 command.
These can be SIS commands for the MLC to act on, or they can be
additional commands for the projector or other devices.
3. Select one or both of the When boxes to choose when the action will occur
(during a button press or a button release), as shown in
3
, below.
4. Select an available port and device.
a. If you chose Driver Operation or User-defined RS-232 operation in
step 2, choose the port the command will be sent to. For both options
you can select from the Projector Port, the IR/Serial ports (A, B, C), or
the slave switcher (MLS) control port. For a user-defined operation you
also have the option to select MLC internal operations.
To Next Page
Loading...