FAAC A1400 AIR - 6. Assembling the Head Section; 6.1 Preparing the Self-Supporting Head Section (if used)

A1400 AIR 21 532129 04 - Rev.B
30
200 200
30 30
37,5
117
55
1
1
2
6
1
8
15
Nm
2
6
6
Nm
Translation of the original instructions
ENGLISH
6. ASSEMBLING THE HEAD SECTION
1. Fasten the support profile to the self-supporting profile 6-

:
- start fastening at a vertical slot at one end and a horizontal slot
at the other end.

Check the horizontal with a spirit level.
- proceed with the other fastenings at a 200 mm distance; alternate
vertical and horizontal slots.
2. Fasten the side brackets at the ends:
- insert the plates into their housings and fasten the 2 side brackets
to the ends of the support profile and self-supporting profile
6-

.

use the screws and the plates supplied

If the A1400 AIR KIT has been supplied, the components must be installed
on the support profile. This operation is performed in the shop. The as-
sembled head section is then moved to the installation site.
For handling instructions see 19.
RISKS
PERSONAL PROTECTIVE EQUIPMENT
REQUIRED TOOLS
Ø 18 mm 6-8-10-13 5
!
A torque wrench must be used to achieve the specified fastening torques
(Nm).
For manual lifting, arrange for an adequate number of people for the
weight of the leaf: 1 person for every 20 kg to be lifted.
6.1 PREPARING THE SELFSUPPORTING HEAD
SECTION (if used)

ONLY in cases where the head section is to be fastened to the side walls,
the self-supporting head section must be prepared:
the support profile, self-supporting profile and the side brackets are as-
sembled before assembling the automation components.