FAAC A1400 AIR - Side Profiles and Casing Brackets Installation; 11.5 Mounting the Side Profiles; 11.6 Installing the Casing Brackets

A1400 AIR 48 532129 04 - Rev.B
H100
61
62
H140
60
1
1
2
1
1
2
2
2
1
2
6
2
Nm
2
6
6
Nm
Translation of the original instructions
ENGLISH
11.5 MOUNTING THE SIDE PROFILES
The side profiles enable the casing to remain closed.
!
If there are no side profiles, cover mounting brackets should be used.
1. Place 6 plates on the support profile (for profiles longer than 3m)
60-

.
2. Mount the side profiles for H100 or H140 casings on the ends of
the support profile.
3. Fasten each side profile using the 3 screws provided 61-

.
!
Use at least one central bracket 62-

for profiles longer than 3 m.
11.6 INSTALLING THE CASING BRACKETS
!
The brackets enable the casing to be closed if side profiles are not used.

Brackets are available for H100 or H140 covers.
It is recommended to use a central bracket for profiles longer than 3 m.
1. Place 2 plates 62-

on the support profile (for profiles longer
than 3 m, a third plate should be added).
2. Mount the brackets and fasten them using the screws provided
62-

.