FAAC A1400 AIR - 18.3 Special Functions

A1400 AIR 89 532129 04 - Rev.B
Translation of the original instructions
ENGLISH
5. If the LK EVO is connected to a A1400 AIR board in which an
unintended function has been programmed, it is overridden with
a different function as indicated:
- from AUTOMATIC ONLY PARTIAL ENTRY
- from AUTOMATIC ONLY PARTIAL EXIT
switches to PARTIAL TWO-DIRECTION AUTOMATIC
- from AUTOMATIC ONLY TOTAL ENTRY
switches to TOTAL TWO-DIRECTION AUTOMATIC
- from PARTIAL NIGHT-TIME
switches to TOTAL NIGHT-TIME
- PARTIAL MANUAL
switches to TOTAL MANUAL
ALARMS
The ALARMS are displayed with a code of flashing LEDs alternating
with the current operating mode.
For the type of ALARM see 25.
6. Other 2-key combinations may be used for the other
special functions.
18.3 SPECIAL FUNCTIONS
RESET:
Reset clears errors in the memory.
It is activated by pressing keys
 and  simultaneously for 5 sec.
The LEDs corresponding to the keys switch on then off.
LOCK/ UNLOCK:
The lock locks and unlocks the keys of the LK EVO
It is activated by pressing keys  and  simultaneously for 5 sec.
The LOCK/ UNLOCK mode change is displayed by switching on for
300msec then switching off the LEDs corresponding to keys.
WARNINGS:
The warnings are displayed by pressing and holding the keys
 and .
The LEDs corresponding to WARNINGS blink for as long as the keys
are held.
For the type of ALARM see 26
FIRMWARE VERSION:
the firmware version of board E1400 can be displayed by pressing
and holding keys  and .
To display the FIRMWARE version see 27
LOCK / UNLOCK
 + 
5 sec.
RESET
 + 
WARNINGS
 + 
continuous
FIRMWARE VERSION
 + 
continuous