A1400 AIR 38 532129 04 - Rev.B
L/3L/3 L/3
L
11
11
Ø 7 mm
48
3 4
1 1
3 4
5
11
9
4
3
7
7
8
9
66
10
7
8
11
Nm
8
6
2.5
Nm
2
10 mm
8 mm
6 mm
Translation of the original instructions
ENGLISH
10. INSTALLING THE GLASS LEAVES
Ø 8.5 mm
bush Ø internal 6 mm
Ø external 8 mm
Ø 6.5 mm with 45° flaring
Ø 5.0 mm with M6 tapping
Ø 7.0 mm
2 x M8
2 x M6
RISKS
PERSONAL PROTECTIVE EQUIPMENT
REQUIRED TOOLS
Ø 5-6.5 mm
45° M6 8 6-8
For manual lifting, there should be 1 person for every 20 kg to be lifted.
!
Comply with the glass thickness =
10-11 mm.
1. The glass must be drilled as shown 48-
.
2. Insert a bush in each hole in the glass 48-
.
3.
Make 2 holes on the profiles of the grip
per 48-
-
.
4. Cut 2 pieces of glass beading with the length equal to L.
5. Drill holes in the seals in correspondence to the holes in the glass
48-
6.
Insert the 2 seals into the profiles 48-
.
7. Clean the glass, insert the gripper.
!
Ensure the beading is in its housing.
8. Assemble the gripper as follows: Insert elements
and
into
the 2 plates
.
9. Tighten the 2 grub screws 48-
10. Part
must be aligned with the fixing holes on the carriage
50-
11. Insert 2 galvanised countersunk head screws into the holes
48-
.
!
The glass must be fully inserted until it touches the clamps on its upper
profile. If the grip of the clamp on the glass is not correct, the glass might
fall. The two clamp profiles must be aligned.
Install each leaf as described below.
1. Disassemble the 2 carriages:
- Tighten the 2 screws 49-
.
- Separate the top plate of the carriage from the bottom plate 49-
and remove the plate
.
2. Position the wheels of the upper plate unit on the sliding guide
3. 50-
(2 plates for each leaf).
4. Adjust the counter wheel to prevent the carriage from falling 50-
.
5. Place the lower plate onto the glass leaf.
- Keep to the measurements indicated in diagrams 117 - 115
and:
- 118 - 116 for RIGHT single leaf automations
- 119- 117 for LEFT single leaf automations
To Next Page
Loading...
