What causes a 'Mag Verify Error' on a FARGO electronics S000256 Printer?
If your FARGO electronics Printer displays 'Mag Verify Error', the Mag Stripe was not encoded properly. See 'Resolving the Mag Verify error message'.
Why is my FARGO electronics S000256 showing 'Head-down Failed'?
If the FARGO electronics Printer displays 'Head-down Failed', the printhead is unable to lower itself. See the 'Resolving the Headlift error message' procedure.
What to do if FARGO electronics Printer displays 'Head-up Failed' error?
If your FARGO electronics Printer displays 'Head-up Failed', the printhead is unable to raise itself. See the 'Resolving the Headlift error message' procedure.
Why am I getting a 'Smart Card Error' on my FARGO electronics S000256 Printer?
If your FARGO electronics Printer displays 'Smart Card Error', it means the printer is unable to encode the smart card. See the 'Resolving the Printer cannot read Encoded Data problem' procedure.
What does 'No Shield Loaded' mean on my FARGO electronics S000256?
If the FARGO electronics Printer displays 'No Shield Loaded', attempts are being made to print with the Printer Driver's SmartShield option selected. If using the SmartGuard feature, insert an access card that contains a SmartShield image or encode a SmartShield image onto the current card and try your print job again. If you do not want to print a SmartShield image, deselect the Printer Driver’s SmartShield option.
What does 'Invalid Key Card' mean on FARGO electronics S000256 Printer?
If your FARGO electronics Printer displays 'Invalid Key Card', the SmartGuard Access Card is either invalid or inserted incorrectly. Insert a valid SmartGuard Card, or reinsert the card properly with the chip end down and facing you.
General| Print Resolution | 300 dpi |
|---|---|
| Interface | USB 2.0 |
| Print Technology | Dye sublimation |
| Card Capacity | 100 cards |
| Supported Card Types | CR80, CR79 |
Instructions for safety purposes that can result in death or serious injury if not followed.
Device is electrostatically sensitive and may be damaged by static electricity discharge.
Adjusts printhead darkness and intensity for dye-sublimation and resin transfer levels.
Configures magnetic encoder intensity, calibrates potentiometers, and adjusts magnetic card offset.
Calibrates the color ribbon sensor to resolve issues with ribbon skipping or incorrect colors.
Safety precautions for performing cleaning procedures, including disconnecting power.
To Next Page
