Faro FaroArm Quantum - Chapter 2: Setting up the Quantum; The Quantum Packing Contents

FaroArm
®
Manual
January 2009
15
Chapter 1: Introduction to the FaroArm
®
• The unknown FARO i-Probe warning - This warning appears when a
FARO i-Probe is attached to a Quantum series FaroArm and never
calibrated. For accurate measuring, you must calibrate the probe. Use
your measuring software to setup and calibrate the probe. See
“Probes” on page 77.
• The missing FARO i-Probe warning - This warning appears when no
probe is attached to a Quantum series FaroArm.
• Other errors appear in a message box.
N
OTE: The FaroArm does not output data until the error has been
cleared.
Figure 1-16 Unknown FARO i-Probe warning
Figure 1-17 Unknown FARO i-Probe warning
08M46E00_FaroArmUSB.book Page 15 Tuesday, February 17, 2009 1:42 PM