FaroArm
®
Manual
January 2009
58
Chapter 1: Introduction to the FaroArm
®
Removing the Battery Pack
Slide the battery pack up to remove.
Charging the Battery Pack
Install the battery pack and connect the FaroArm to a power outlet and
the battery will begin to charge. The battery will charge if the On/Off
switch is set to OFF. Charging automatically stops when the battery
pack is completely charged. The D
IAGNOSTICS dialog box displays the
current status of the battery pack. See “Diagnostics” on page 87.
WARNING: Only use the rechargeable battery pack supplied with
your FaroArm. For information on ordering additional or replacement
battery packs, contact FARO’s Customer Service by Phone, Fax or E-
Mail. See “Technical Support” on page 93.
Figure 1-42 Removing the battery
08M46E00_FaroArmUSB.book Page 58 Tuesday, February 17, 2009 1:42 PM
To Next Page
Loading...