FaroArm
®
Manual
January 2009
56
Chapter 1: Introduction to the FaroArm
®
FaroArm Power Supply
Power the FaroArm with the supplied power supply. The power supply
is NRTL Listed for US and Canada. For IEC member countries and
Europe, the power supply must be certified for the country in which the
equipment is sold. Contact FARO’s Customer Service to order a
replacement. All servicing should be referred to qualified service
personnel.
CAUTION (INDOOR USE ONLY)
Supplying Power to the FaroArm
Place the FaroArm in an area with a properly grounded outlet
receptacle. Ensure the On/Off switch is on the OFF position before
supplying power.
WARNING: Do not disconnect or isolate the ground pin on the power
supply cord.
Select the proper power supply cord intended for installation in a
protected environment. The power supply automatically adjusts to the
voltage.
Rated Voltage: 110 - 240V ~ 50 - 60 Hz
Voltage Tolerance: +10% or -10%
Rated Input: 0.8A
Sec. Voltage: +12 VDC
Sec. Current: 2A
Pollution Category: 2
Installation Category: 2
Figure 1-39 Mounting the Platinum/Fusion
Series FaroArm
Figure 1-40 Mounting the Quantum Series
FaroArm
USB
PORT
On/Off
SWITCH
08M46E00_FaroArmUSB.book Page 56 Tuesday, February 17, 2009 1:42 PM
To Next Page
Loading...
Need help?
General