FaroArm
®
Manual
January 2009
57
Chapter 1: Introduction to the FaroArm
®
• For 120V Connection: Use a UL Listed, type SJT or SVT, 3-
Conductor, 18 A.W.G. power supply cord, terminating in a molded-on
plug cap rated 125 VAC, 15A minimum, with a minimum length of
six feet.
• For 220 - 240V Connection: Use an international harmonized, 300V
rated, PVC insulated jacket, three conductors of 0.75mm
2
minimum
cross-sectional area, each with a molded-on plug cap marked with
proper agency marking for the country where it will be used.
N
OTE: Power surges, spikes, feedback, and fluctuation in the power
source will affect the equipment and its electronic accessories. Please
have your power source inspected by a professional to provide the
cleanest power source possible.
FaroArm Battery Pack
Your FaroArm may be powered using the supplied battery pack. Install
the battery pack to power your FaroArm when you are not near a
grounded power outlet.
N
OTE: It is not necessary to install the battery pack if the FaroArm is
connected to a power outlet.
Installing the Battery Pack
Slide the battery pack in and down until it clicks.
Figure 1-41 Installing the battery
08M46E00_FaroArmUSB.book Page 57 Tuesday, February 17, 2009 1:42 PM
To Next Page
Loading...
Need help?
General