FaroArm
®
Manual
January 2009
73
Chapter 1: Introduction to the FaroArm
®
Laser Line Probe Calibration
Ensure the Scan Rate and Scan Density are set 1/1. From the host
application select "Scanner Options" or "Scanner Controls" to access
the settings dialog box.
Perform the calibration at least 3 times. See “Calibration” on
page 32.
N
OTE: Never grab the Laser Line Probe while measuring. Simply
hold the arm's pistol grip. Holding the Laser Line Probe can cause
inaccuracy due to bending of its mounting bracket.
08M46E00_FaroArmUSB.book Page 73 Tuesday, February 17, 2009 1:42 PM
To Next Page
Loading...
