FaroArm
®
Manual
January 2009
72
Chapter 1: Introduction to the FaroArm
®
Clean the top and bottom lenses with the cloth from the Laser Line
Probe case. Dirt and grease on either lens can cause poor results.
Place the calibration plate approximate 2/3 of the FaroArm's reach
away from its base.
N
OTE: Secure the plate firmly to the table. If you are clamping at
more than one location, make sure that the surface is flat so that the
plate does not bend. Clamping only on one end may create a “spring
board” effect.
08M46E00_FaroArmUSB.book Page 72 Tuesday, February 17, 2009 1:42 PM
To Next Page
Loading...
Need help?
General