FaroArm
®
Manual
January 2009
49
Chapter 1: Introduction to the FaroArm
®
The specifications of your FaroArm are listed on the serial number label
on the left side of the base.
N
OTE: For optimum performance, correctly mounting and operating
the FaroArm is very important. For more information, see “FaroArm/
ScanArm Performance Verification Checklist” on page 66.
Volumetric Maximum Deviation
This value is determined by using traceable length artifacts, which are
measured at various locations and orientations throughout the working
volume of the FaroArm. This test is a method for determining
articulating measurement machine accuracy. The deviation value is the
difference between the measured values and the true, or nominal, value.
S/NS/N
ModelModel
RevRev
Single PointSingle Point
VolumetricVolumetric
Certification Certification
DateDate
MADE IN U.S.A.
P08-02-07-05675
P08
26.2
Aug18, 2007
+/- .036 mm.
+/- .025 mm.
08M46E00_FaroArmUSB.book Page 49 Tuesday, February 17, 2009 1:42 PM
To Next Page
Loading...
Need help?
General