FaroArm
®
Manual
January 2009
65
Chapter 1: Introduction to the FaroArm
®
• I have an i-Probe attached but see this error dialog box and can not
measure. What is wrong?
Ensure that the i-Probe is threaded on all the way. If the system
still does not recognize it, the i-Probe may be damaged and may
need to be replaced.
• I have an old probe attached but see this error dialog box and can not
measure. What is wrong?
You must clear the U
SE I-PROBE check box in the PROBE dialog
box. For more information, see “Probes” on page 77.
• How many i-Probes can a FaroArm remember?
112
08M46E00_FaroArmUSB.book Page 65 Tuesday, February 17, 2009 1:42 PM
To Next Page
Loading...
Need help?
General