OPERATION MT100 Multipoint Flow Meter
Command 1: Read Primary Variable (Flow Units, & Flow Value)
Primary Variable Units Code
No Command-Specific Errors
Command 2: Read Primary Variable Loop Current and Percent of Range
Primary Variable Loop Current (mA)
Primary Variable Percent of Range (%)
No Command-Specific Errors
Command 3: Read Dynamic Variable (Flow) and Loop Current
No Command-Specific Errors
Command 6: Write Polling Address
Polling Address of Device
Polling Address of Device
No Command-Specific Errors
Invalid Poll Address Selection
Fluid Components International LLC 48
To Next Page
Loading...
