MT100 Multipoint Flow Meter OPERATION
4. With the password entry screen on display tap in 8FE# followed by ENTER. The FE Control screen displays again, this time with
“Password Entered” showing on the upper right.
5. Tap on the FE that you want changed to the other state. This brings up a screen showing Online and Offline. Current status is the
one shaded. Tap on the unshaded item to change the FE’s ON/OFF status and to return to the FE Control screen. Tap QUIT to exit
the menu.
Using Digital Outputs
Digital busses (includes HART, Modbus, and FOUNDATION Fieldbus/PROFIBUS) are mutually exclusive, meaning only one can be active at
a time. When a particular digital output is specified at order time the unit is configured appropriately at the factory. Use the MT100
configuration software (Configuration/Output) to change the digital output selection. Refer to the MT100 Configuration Software manual
06EN003461 for details.
F
OUNDATION Fieldbus/PROFIBUS operation requires the optional Fieldbus/PROFIBUS add-on card. See Figure 23, page 26 for the add-on
card location.
Fluid Components International LLC 41
To Next Page
Loading...
