FCI MT100 - Page 62

OPERATION MT100 Multipoint Flow Meter
Command 48: Read Additional Device Status
Byte
Format
Description
Request Data Bytes
0–5
Bits
Device-Specific Status (only first 6 bytes used, see page 70 for
additional info)
6
Bits
Extended Device Status. Normally “0”; set to “1” (0x01) if
maintenance is required.
7
Bits
Device Operating Mode (not used, bit cleared to 0)
8
Bits
Standardized Status 0 (not used, bit cleared to 0)
9
Bits
Standardized Status 1 (not used, bit cleared to 0)
10
Bits
Analog Channel Saturated (not used, bit cleared to 0)
11
Bits
Standardized Status 2 (not used, bit cleared to 0)
12
Bits
Standardized Status 3 (not used, bit cleared to 0)
13
Bits
Analog Channel Fixed
14–24
Bits
Device-Specific Status2 (not used, bit cleared to 0)
Response Data Bytes
0–5
Bits
Device-Specific Status (only first 6 bytes used, see page 70)
6
Bits
Extended Device Status. Normally “0”; set to “1” (0x01) if
maintenance is required.
7
Bits
Device Operating Mode (not used, bit cleared to 0)
8
Bits
Standardized Status 0 (not used, bit cleared to 0)
9
Bits
Standardized Status 1 (not used, bit cleared to 0)
10
Bits
Analog Channel Saturated (not used, bit cleared to 0)
11
Bits
Standardized Status 2 (not used, bit cleared to 0)
12
Bits
Standardized Status 3 (not used, bit cleared to 0)
13
Bits
Analog Channel Fixed
14–24
Bits
Device-Specific Status2 (not used, bit cleared to 0)
Code
Class
Description
Response Codes
0
Success
No Command-Specific Errors
1–4
Undefined
5
Error
Too Few Data Bytes Received
6–13
Undefined
14
Warning
Status Bytes Mismatch
15–127
Undefined
Fluid Components International LLC 54