Festo CPX-CMAX - Page 97

Axis controller CPX-CMAX
Festo – P.BE-CPX-CMAX-SYS-EN – en 2017-09b – English 97
Load 25.................................
Logic 0 95...............................
Logic 1 95...............................
M
Mass moment of inertia 26..................
Mounting
– Drive 23...............................
– Fixed stops 23..........................
Mounting position 25, 27...................
Mounting position (of the axis) 26............
N
Notes on the documentation 6...............
O
Operating mode 95........................
P
Parameter 95.............................
Payload 25...............................
PLC/IPC 95...............................
PNU 95.................................
Position control 95........................
Positioning system 15......................
– Commissioning options 49................
– Parameterisation options 49...............
– Structure 15............................
Power supply 44..........................
Power supply concept 45...................
Pressure control 95........................
Project zero point 95.......................
R
Record 95...............................
Reference point (REF) 95...................
Reset type 68............................
S
Safety instructions (general) 10..............
Service 7................................
Software end position 95...................
– Negative (lower) 95......................
– Positive (upper) 95......................
Software status, CPX node 13...............
Software version, CMAX 7...................
Start-up characteristics performance 52.......
Status display 63.........................
Status information 63, 66...................
Switching off the load supply 47.............
T
Target group 7............................
Technical data 89.........................
Total load 25.............................
– Maximum total load 26...................
– Minimum total load 25, 26................
Transport and storage conditions 12..........
Tubing 38................................
Type code 8..............................
V
Voltage zones 45..........................
W
Warnings 67, 70...........................