Festo EMCS-ST - Safety; Safety instructions

Festo — EMCS-ST — 2021-03b
Safety
7
1.3 Product labelling
1
Fig. 1: Product labelling
1
Product labelling (product information,
approvals, warning symbol)
Warning symbol
Warning
symbol
Meaning
Attention! Hot surface
Metallic housing parts of the device can reach high temperatures during operation. In
the event of a fault, internal components may become overloaded.
Tab. 2: Warning symbol
1.4
Specified standards
Version
IEC 60204-1:2005+AMD1:2008 CSV EN 61800-5-1:2016-08
IEC 61131-2:2013 EN 60034-1:2011-02
EN 61800-2:2016 EN 60204-1:2006+A1:2009+AC:2010
Tab. 3: Standards specified in the document
2 Safety
2.1 Safety instructions
– Only use the product if it is in perfect technical condition.
– Only use the product in original status without unauthorised modifications.
–
Do not carry out repairs on the product. Replace defective product immediately.
–
Observe labelling on the product.
– Never remove or insert a plug connector while live.