Festo EMCS-ST - Intended use; Product overview; Function

8
Festo — EMCS-ST — 2021-03b
Product overview
–
Once installed, only operate the product if all the necessary protective measures have been imple-
mented è EN 60204-1.
–
Before working on the product: switch off the power supply, check that no voltage is present and
secure against being switched on again.
–
Store the product in a cool, dry environment that is protected against UV and corrosion. Ensure
short storage times.
2.2 Intended use
The EMCS-ST integrated drive is used as intended to drive the connected actuator technology. The
integrated electronics enable control of position, speed or force/torque.
2.2.1 Application areas
The device is intended for use in an industrial environment. Outside industrial environments, e.g. in
commercial and residential/mixed-use areas, it may be necessary to take measures to suppress radio
interference.
2.3 Training of qualified personnel
Work on the product may only be carried out by qualified personnel who can evaluate the work and
detect dangers.
The qualified personnel have knowledge and experience in dealing with electric drive systems.
2.4
Approvals and certifications
CE approval (conformity)
In conjunction with the CE mark on the product, the EC directives and standards listed below in the
Declaration of Conformity
è
www.festo.com/sp apply.
–
in accordance with EU EMC Directive
– in accordance with EU RoHS Directive
KC certification
KC number: R-R-FTO-KC-2018-1082
RCM certification
The product fulfils the EMC requirements for Australia and New Zealand with the RCM certification
mark on the product.
3 Additional information
– Contact the regional Festo contact if you have technical problems
è
www.festo.com.
– Accessories and spare parts
è
www.festo.com/catalogue.
4 Product overview
4.1 Function
The following components are integrated in the EMCS-ST integrated drive for all product variants:
–
Stepper motor for driving the connected actuator technology
–
Encoder for detecting the current position
– Electronics for DC link voltage conditioning
– Power stage for actuation of the motor
– Temperature sensors for monitoring the power stage temperature