4.2 SIEMENS
General
This chapter describes the entries required for
configuring a valve terminal for a Siemens DP
master. In order to understand this chapter, you
must use your configuration program correctly.
Different configuration programs are available,
depending on the control system used (S5,
S7, ...).
Examples
• COM ET200 (DOS version)
• COM ET200 (Windows version)
• COM PROFIBUS
• SINEC NCM S7 PROFIBUS
• STEP 7 (V2.X)
• SINEC NCM
• ...
The configuration programs are subject to modi-
fications which may not already have been taken
into account in this manual.
VIFB13 - 03/05 4. Commissioning
9701 NH 4-21
To Next Page
Loading...
