3. Installation
3-11
Festo P.BE-SPC11-SYS-ASI-EN en 0203NH
Drive ( 6 )
Use only the permitted combinations of drives and measuring
systems approved of by Festo for the SPC11.
The drive-valve combinations, cylinder diameters, cylinder
lengths and mass loads permitted for the drive used can be
found in the manual “Drive-specific supplement... .”
Connect the cylinder, the guide, the potentiometer and the
load free of play in the direction of movement and flush with
each other.
Ifnecessary,provideasufficientlylargesupplyofenergyin
order to minimize the effects of transverse forces on the posi-
tioning behaviour .
Observe the maintenance intervals specified in the operating
instructions for the drive (see operating instructions for the
cylinder/drive or the guide).
To Next Page
Loading...
Need help?
General
