Contents and general instructions
III
Festo P.BE-SPC11-SYS-ASI-EN en 0203NH
Contents
Designated use V........................................................
Service VI...............................................................
Target group VI..........................................................
Important user instructions VII..............................................
Product-specific terms and abbreviations IX...................................
Notesontheuseofthismanual XI...........................................
1. Summary of components 1-1........................................
1.1 Structure 1-3......................................................
1.2 Method of operation 1-7............................................
1.3 Display and connecting elements on the SPC11 1-9......................
1.4 Method of working as an AS-Interface slave 1-10.........................
2. Fitting 2-1........................................................
2.1 Fitting the SPC11 2-3...............................................
3. Installation 3-1...................................................
3.1 General instructions on installation 3-3................................
3.2 Notes on installing the pneumatic components 3-4.......................
3.2.1 Pneumatic emergency stop circuit 3-15.................................
3.3 Installing the electronic components 3-19...............................
3.3.1 Connecting elements of the SPC11 3-20.................................
3.3.2 Assigning the AS-Interface slave addresses 3-21..........................
3.3.3 Selecting the power unit 3-24.........................................
3.3.4 Connecting the operating voltage and the AS-Interface bus 3-25.............
3.3.5 Connecting the proportional directio nal control val ve and
the measuring system 3-31...........................................
To Next Page
Loading...
Need help?
General
