Festo Soft Stop SPC11 Series User Manual

3. Installation
3-25
Festo P.BE-SPC11-SYS-ASI-EN en 0203NH
3.3.4 Connecting the operating voltage and the A S-Interface bus
Recommendation: In order to connect the load voltage cable
and the AS-Interface bus cable use the following accessories
from Festo:
Accessories
Type designation
AS-Interface combi power pack ASI-CNT-115/230VAC
AS-Interface bus cable (yellow) KASI-1.5-Y-100
Additional supply cable (black) KASI-1.5-Z-100
AS-Interface cable cap ASI-KK-FK
AS-Interface cable socket ASI-SD-F K or ASI-SD-F K180
Addressing device ASI-PRG-ADR
Identification labels ISB6x10
Installation instructions
Caution
In order to avoid interference caused by electromagnetic
influences:
S Connect the earth connection on the left-hand side of the
housing with low impedance (short cable with large
cross-sectional area) to the earth potential.
S Connect a protective conductor with sufficient cross
sectional area to the drive, if this is not mounted on an
earthed machine stand.

Festo Soft Stop SPC11 Series Specifications

General

Brand	Festo
Model	Soft Stop SPC11 Series
Category	Control Unit
Language	English