EasyManuals Logo

Festo Soft Stop SPC11 Series User Manual

Festo Soft Stop SPC11 Series
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
4. Commissioning
4-3
Festo P.BE-SPC11-SYS-ASI-EN en 0203NH
4.1 General instructions on commissioning
This chapter describes parametrizing and commissioning with
the aid of the three buttons on the SPC11. For commissioning
via the keyboard the AS-Interface cable (bus) must be discon-
nected or without power applied.
If you use slave p rofile 7.4, you can carry out commissioning
via the AS-Interface bus. Detailed information can be found in
Appendix A.
Warning
During c ommissioning and during operation the moveable
mass is moved at the highest possible acc eleration and
speed. Make sure that:
nobody can place his/her hand in the positioning range
of the moveable mass, unless the compressed air supply
is switched off.
the complete positioning range is free of any objects.
Warning
Incorrectly set parameters can damage the fixed stops and
the drive.
Be very careful when setting the parameters.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Festo Soft Stop SPC11 Series and is the answer not in the manual?

Festo Soft Stop SPC11 Series Specifications

General IconGeneral
BrandFesto
ModelSoft Stop SPC11 Series
CategoryControl Unit
LanguageEnglish

Related product manuals