PREFACE 14
Precautions
Always observe the following general precautions when installing and servicing the E-41:
• Avoid pressing the surface of the LCD.
Applying excessive pressure to the LCD window will cause it to change color.
• Use a soft cloth moistened with Lens and Mirror Cleaner to clean the surface of the E-41
display window.
Other solvents, such as water, may damage the polarizer on the display window.
Never lift the E-41 by grasping the top panel. The top panel does not support the weight of
the system.
ATTENTION:
Ne jamais soulever le serveur d’impression par sa partie supérieure : celle-ci ne peut pas supporter le poids du système.
AVVERTENZA: Il server di stampa non deve essere mai sollevato afferrandolo dal pannello superiore, in quanto quest’ultimo non
può sostenere il peso dell’intero sistema.
WARNUNG: Heben Sie den Druckserver nicht an der oberen Gehäuseabdeckung an. Die obere Gehäuseabdeckung ist nicht dafür
ausgelegt, das Gesamtgewicht des Systems zu tragen.
DVERTENCIA: No levante nunca el servidor de impresión agarrándolo por el panel superior. El panel superior no soporta el peso
del sistema.
ADVERTÊNCIA: Nunca erga o servidor de impressão pelo painel superior. O painel superior não suporta o peso do sistema.
WAARSCHUWING: Til de afdrukserver nooit op door het bovenpaneel vast te nemen. Het bovenpaneel kan het gewicht van het
systeem niet dragen.
• When connecting or disconnecting the power cord:
– Only use the power cord that shipped with the E-41 or an appropriate replacement power
cord available from an authorized provider.
– Always disconnect the power cord from the E-41 back panel before opening the unit and
servicing internal components.
– Do not pull on the power cord when unplugging the E-41. Pull the plug instead.
– Do not place objects on the power cord. Place the power cord away from foot traffic.
– Do not tamper with or disable the power cord grounding plug.
– Do not use a 3-prong adapter in a 2-hole ungrounded outlet.
– Do not use an extension cord.
– Do not plug the E-41 into a circuit with heating or refrigeration equipment (including
water dispensers).
– Do not plug the E-41 into a switchable power outlet. This can result in the E-41 being
turned off accidentally.
• Never set any liquid on or near the E-41 or copier/printer. If liquid is spilled into the E-41 or
copier/printer, disconnect the power cord immediately.
• Do not attempt to open the power supply, DVD drive, or hard disk drive (HDD).
To Next Page
Loading...