USING THE E-41 38
Printable Info menu
This section describes how to print pages such as the Test Page and Configuration page from
the Printable Info menu (described on page 37). The Printable Info menu is accessed through
the Fiery tab (see page 37).
Printing the Configuration page can be helpful during installation, Setup, and service. After
installing the E-41 (including connecting to the network), and before default settings are
changed in Run Setup, you can obtain a record of the defaults by printing the Configuration
page.
Before you perform any service procedure, you should print the E-41 Configuration page, if
possible, so you are prepared to return the settings to their former configuration, if necessary.
Printing the Te st Pa g e indicates that the E-41 is functional and that the connection between
the E-41 and the copier/printer is working.
TO PRINT A PAGE FROM THE PRINTABLE INFO MENU
1. If it is not powered on already, power on the copier/printer and allow it to warm up.
2. If it is not powered on already, power on the E-41 using the power button on the front panel
and allow it to start up completely (approximately three minutes).
3. Make sure that Idle appears on the Fiery Main menu.
If Busy or Printing appears, the E-41 is processing and you must wait until Idle appears.
4. Touch the Fiery tab.
5. Touch Printable Info and then select the page that you want to print.
The E-41 sends the selected page(s) to the copier/printer.
6. If you printed the Test Page, examine the quality of the page.
If the Test Page prints, you know the E-41 is functional and the connection between the E-41
and the copier/printer is working. If the Test Page fails to print, look up printing problems in
the Troubleshooting table on page 139.
When you examine the Test Page, keep in mind the following:
• All color patches should be visible, even though they may be very faint in the 5% and 2%
range.
• Each color’s patch set should show uniform gradation from patch to patch as the color
lightens from 100% to 0%.
Poor image or color quality may indicate a need to calibrate the system or service the copier/
printer. Information on the Test Page includes the date and time of the last calibration, so the
Test Page can be kept for future reference. For more information, look up printing problems
in Table 6-3 on page 6-13, or see Color Printing on the User Documentation CD.
To Next Page
Loading...