INSTALLATION 22
INSTALLATION
This chapter includes information about the following:
• Installation sequence (see below)
• Checking the customer site (see page 24)
• Unpacking the E-41 (see page 26)
• Installing the E-41 and connecting it to the copier/printer and network (see page 28)
• Completing the installation (see page 31)
– Print a Test Page and Configuration page (page 37).
– Remind the site administrator to install current user software on networked computers
that print to the E-41 (see Printing and Utilities on the User Documentation CD).
Installation sequence
Familiarize yourself with this chapter before you attempt an installation. The installation
sequence described in this chapter is designed to make your job as easy as possible. Installation
problems are easier to avoid and diagnose if you proceed from the component to the system
level and verify functionality at each stage. Figure 3 on page 23 outlines the recommended
installation procedure for connecting the E-41 to the copier/printer.
Because the E-41 is a node on the customer’s computer network, make sure that you
coordinate your scheduled installation with the network administrator at the customer site.
For Network Setup information, refer the network administrator to Configuration and Setup
on the User Documentation CD.
NOTE: You can change the default language preinstalled at the factory using the Configure
tool available through Command WorkStation and WebTools. Launch Configure and then
navigate to Server > General > Choose Server Language and then click Apply.
To Next Page
Loading...