Fiery E-41 - Networking and Connectivity; User Software; Safety and Emissions Compliance

SPECIFICATIONS 145
Networking and connectivity
• Supports AppleTalk and TCP/IP protocols simultaneously.
• Supports EtherTalk Phase 2 (allows users to print from a Mac OS computer to the E-41
using the AppleTalk network protocol over an Ethernet network).
• RJ-45 connector (lower port) that provides the print and scan interface between the E-41
and the copier/printer.
• RJ-45 connector (upper port) that supports 10BaseT/100BaseTX/1000BaseT twisted pair
network connectivity.
The copier/printer interface cable included with the E-41 is a 39.3 ft./12m Ethernet crossover
cable that connects to the lower RJ-45 port on the E-41 back panel. The network cable at the
customer site is a straight-through Ethernet cable that connects to the upper RJ-45 port on the
E-41 back panel. The cables look similar but are not interchangeable. Make sure that you
connect the cables to the correct ports (see Figure 6 on page 28 and Figure 7 on page 29).
User software
A complete description of user software is provided in Welcome on the User Documentation
CD. For optimal performance, maintain current versions of the user software on every
network computer used to print to the E-41. User software may be installed directly on client
computers equipped with a DVD drive, or over a network via the Fiery User Software
Installer that resides on the E-41.
Safety and emissions compliance
The E-41 has been certified to meet or surpass the following government standards:
Safety approvals EMI/EMC approvals
• UL 60950-1, 2nd Edition, 2007-03-27 • FCC Class A
• CSA-22.2 #60950-1-07, 2nd Edition, 2007-03 • VCCI Class A
• EN 60950-1: 2006+A11 (TUV/GS mark) • EN55022: 2006+A1: 2007 Class A
• CB scheme IEC 60950-1: 2001 (1st Edition) • EN55024: 1998+A1: 2001&A2: 2003
• CB scheme IEC 60950-1: 2005 (2nd Edition) • AS/NZS CISPR22: 2006-Class A