USING THE E-41 42
TO SHUT DOWN, RESTART, OR REBOOT THE E-41 FROM THE COPIER/PRINTER DISPLAY PANEL
1. Press the “fierydriven®” button on the copier/printer and make sure that Idle appears on the
copier/printer display panel (see page 35).
If the system has just finished processing, wait at least five seconds after the system reaches
Idle before beginning the shutdown procedure.
NOTE: Notify the network administrator before you remove the E-41 from the network.
2. Press the Fiery tab.
3. Press Restart Fiery.
4. At the next screen, select one of the following options:
• Restart Fiery Service (soft reset)—Resets the E-41 server software but does not reboot the
entire system. Network access to the E-41 is temporarily interrupted and all currently
processing jobs are aborted and may be lost. If you choose this option, you may need to
wait 1 minute or more for the server software to reset.
•
Reboot System (hard reset)—Shuts down all E-41 activity properly and then reboots.
Network access to the E-41 is temporarily interrupted and all currently processing jobs are
aborted and may be lost.
•
Shut Down—Shuts down all E-41 server software and powers off the system. You should
always select this option when you want to power off the system. Network access to the
E-41 is terminated and all currently processing jobs are aborted and may be lost.
NOTE: Use the reset button on the front of the E-41 only if the system is unresponsive to
keyboard or mouse actions.
5. Press OK.
Before accessing internal components, make sure that all cables are disconnected from the
back of the E-41.
To Next Page
Loading...