SERVICE PROCEDURES 96
10. If you replaced the HDD with a new HDD, install system software (see page 105).
Troubleshooting tips:
• Following system software installation, if the E-41 boots up much slower than usual, clear
the CMOS as follows:
– Make sure that the power cable is removed from the power outlet, and then remove the
battery (see page 84).
– Wait 2 minutes to allow the motherboard electrical components to fully discharge.
– Reinstall the battery.
– After reassembling the system, reset the time and date in Setup (see Configuration and
Setup on the User Documentation CD).
• If a startup error displays on the Control Panel when you power on the E-41, check the
connections.
11. Verify functionality (see page 104).
To Next Page
Loading...