44
REV. 00 02/01/2015
id.:
CBV ADVANCED MODE FUNCTIONS
3
3.7.3 Use of the moisture probe
If you set the use of the moisture probe, you do not need to enter the humidity value; the system will automatically
detect it during weighing
3.8 SELECTING THE VOLUME
From the “FUNCTION” menu select “SETUP VOLUME”
Press OK
to edit the volume
Enter the volume you want to produce
Press OK
to confi rm and return to the
“FUNCTION” menu
press ESC
from the “FUNCTION” menu to go
back to the main page (recipe)
To set up the volume to produce from
the selected recipe
Vehicle limits
3.9 AUTOMATIC WATER LOADING
Select the “WATER” component
Press OK
(a message is displayed)
Press OK
again to confi rm or ESC to
return to the previous step.
When the OK key is pressed, the water loading phase
starts; the loading progress is visible.
The water loading phase may be started through an
external device (Mix control); the device automatically
turns the pump off as soon as the preset value is
reached.
The water loading phase is carried out until the
set threshold is reached (e.g. 70%).
The remaining water will be loaded at the end of the loading phase by repeating the automatic water
loading operation.
Select the next component (e.g. CEMENT)
To Next Page
Loading...
Need help?
General