EasyManua.ls Logo

Fischer Panda 7K PMS - Maintenance Instructions; Personal requirements

Fischer Panda 7K PMS
168 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance Instructions
22.10.19 Kapitel/Chapter 6: Maintenance Instructions - Seite/Page 91
6. Maintenance Instructions
6.1 Personal requirements
The maintenance described here can be carried out by the operator unless otherwise indicated.
Further maintenance work may only be carried out by specially trained specialist personnel or authorized repairers
(Fischer Panda Service Points). This is especially true for work on the valve setting, diesel injection system and for
engine repair.
Attention!The work described here can be taken as a guide. Since
Fischer Panda does not know the exact installation and
storage conditions, the work instructions and materials
must be adapted by a local specialist. Damages caused
by improper maintenance / repair are not covered by the
warranty.
6.1.1 Hazard notes for the maintenance
Note!Follow the general safety instruction at the front of this
manual.
Warning! Automatic startDanger for life! - The generator can be equipped with a
automatic start device. This means the generator can be
started by an external signal. To avoid an unexpected
starting of the generator, the starter battery must be
disconnected before start working at the generator.
Warning! Risk of injuryWorking at a running generator can result in severe
personal injury. Therefore before starting work at the
generator:
Make sure that the generator is stopped and the starter
battery is disconnected to guarantee that the generator
cannot be inadvertently started.
Do not run the generator with removed sound isolation cover
Warning! Risk of injuryImproper installation/maintenance can result in severe
personal injuries or material damage.
Always undertake installation/maintenance work when the
generator is switched off.
Ensure there is sufficient installation clearance before start
working.
Ensure tidiness and cleanliness at the workplace. Loose
components and tools lying around or on top of each other
are sources of accidents.
Only perform installation work using commercially available
tools and special tools. incorrect or damaged tools can
result injuries.

Table of Contents

Related product manuals