Maintenance Instructions
22.10.19 Kapitel/Chapter 6: Maintenance Instructions - Seite/Page 121
6.16 Replacing the operating current relays
NOTE:Representative procedureThe described procedure is representative for Fischer Panda
generators. The original location of the item must be taken
from the generator description of this manual. All
replacements and repairs can be done by the user.
Fig. 6.16-1: Relay1. Remove the two fixing screws of the plastic cover using a
size 0 or 1 phillips screwdriver.
Fig. 6.16-2: Relay2. Remove the plastic cover.
Fig. 6.16-3: Relay3. Pull relay from the socket and replace with new relay.
4. To reinstall, reverse the order of steps.
6.17 Replacing the fuses
NOTE:Representative procedureThe described procedure is representative for Fischer Panda
generators. The original location of the item must be taken
from the generator description of this manual. This
replacement can be done by the user.
The fuses should be replaced every 2000 operating hours.
To Next Page
Loading...
