Gauge for measurement of the ferrite content in autenitic and duplex steel
FERITSCOPE® DMP30 (1007334)
On our home page www.helmut-fischer.com you will find the addresses of our
sole agencies and subsidiary companies around the globe.
© 2023 by Helmut Fischer GmbH Institut für Elektronik und Messtechnik, Ger-
many.
This document is protected by copyright. All rights reserved. This document
may not be reproduced by any means (print, photocopy, microfilm or any other
method) in full or in part, or processed, multiplied or distributed to third parties
by electronic means without the written consent of Helmut Fischer GmbH Insti-
tut für Elektronik und Messtechnik.
Subject to correction and technical changes.
FERITSCOPE® is a registered trade mark of the Helmut Fischer GmbH Institut
für Elektronik und Messtechnik in Germany and other countries.
Microsoft
TM
and Excel
TM
are registered trade marks of the Microsoft Corporation,
USA.
Bluetooth® is a registered trade mark of the Bluetooth SIG, USA.
Gorilla® Glass is a registered trade mark of the Corning Incorporated, USA.
Note: Designations not marked with ® or ™ may also be protected by law.
Document Number: 1009523
Edition: 04-2023 (from Firmware version 1.0.0)
Manufacturer
Helmut Fischer GmbH Phone: +49 (0) 70 31 3 03 - 0
Institut für Elektronik und Messtechnik Fax: +49 (0) 70 31 3 03 - 710
Industriestraße 21 www.helmut-fischer.com
D-71069 Sindelfingen mail@helmut-fischer.com
Quality Assurance System of the Helmut Fischer GmbH Institut für Elektronik
und Messtechnik
DIN EN ISO/IEC 17025 Calibration lab accredited for certified mass per unit
area standards
DIN EN ISO 9001:2015 Management system certified by Swiss Association
for Quality and Management Systems (SQS)
To Next Page
Loading...
