FISCHER FERITSCOPE DMP30 - Opening a Batch; Activating;Deactivating Specification Limit Monitoring

35
FERITSCOPE® DMP30 Settings for measurement
4. Make the desired batch settings for the measurement 35, assign a batch
name, 84
This completes the creation process for a new batch.
5. Call up the Measurement view for the new batch: MEASURE > OK.
Creating a new batch by copying
You use the Copy function to create a batch by copying a selected batch. Apart from
the measured readings and the batch name, the batch copy contains all the settings
of the batch copy template.
► > Batches > OK >select a batch as a copy template from the list> OK > Copy
> OK > The Measurement view of the newly created batch appears in the display
 Measurement settings, see from page 35
 Assign calibration, see page 41
 Check calibration, see page 65
 Rename a batch, see page 84
7.2 Opening a batch
► > Batches > OK > select desired batch from the batch list > OK
The Measurement view of the selected batch appears in the display.
 Measure, see from page 42
 Check calibration, see page 65
7.3 Activating/deactivating specification limit monitoring
Before you start
 The batch for which you want to make the changes is open in the gauge.
[ ]
[ ]