79
FERITSCOPE® DMP30 Batch settings
12 Batch settings
For the open batch, you can make settings that do not directly affect the measure-
ment, such as changing the Measurement view, the max. number of decimal places
for the displayed values or calling up the batch information.
12.1 Calling up information about the open batch
You can call up information about the open batch. All settings, assigned calibration
and probe information used to create this batch are listed on an information page.
Before you start
The batch for which you want to view the information is open in the gauge.
To call up information about the open batch
1. > Batch Modify > OK > Batch Info > OK
2. Exit the information page:
Description of parameters on page Batch Info
Batch Name
Name of the batch file.
Probe Name
Name of the probe used to create this batch.
Probe Serial Number
Serial number of the probe used to create this batch.
Calibration
Name of the calibration assigned to this batch.
Limits [FN]
Information on specification limit monitoring: off or indication of the specification
limits (LSL and USL)/ the specification limit (LSL).
[ ]
To Next Page
Loading...
