FISCHER FERITSCOPE DMP30 - Selecting the Measurement View for the Batch

81
FERITSCOPE® DMP30 Batch settings
12.2 Selecting the Measurement view for the batch
You can display various items of additional information for the open batch. You can
choose between two Measurement views.
Before you start
 The batch for which you want to make the changes is open in the gauge.
To select a Measurement view
1. > Batch Modify > OK > Views Settings > OK > Measurement View > OK > select
desired Measurement view > OK
Measurement view is activated:
The display screens below should be considered only as examples; batch 004 has set specifica-
tion limits.
Batch 004
BLOCK
71.3
FN
55.0
i75.0
Batch 004
No. 6 n 3
66.81 s 4.77
Min 61.8 Max 71.3
x
BLOCK
71.3
FN
i55.0
i75.0
Measurement view
Simple
Measurement view
Statistics (default mode)
Only the current measured
reading is displayed.
In addition to the current
measured reading, a mea-
sured reading statistic is
shown in a table.
[ ]