FISCHER FERITSCOPE DMP30 - Activating;Deactivating Offset Function

37
FERITSCOPE® DMP30 Settings for measurement
To activate automatic block formation and set the desired block size
1. > Batch Modify > OK > Block Size > OK > Generate autom. > OK.
Parameter is activated:
2. Set the block size: Block Size > OK > set desired value > OK.
3. Exit the menu: , the settings are now made.
To deactivate automatic block formation
1. > Batch Modify > OK > Block Size > OK > Generate autom. > OK.
Parameter is deactivated:
2. Exit menu: , automatic block formation is deactivated.
7.5 Activating/deactivating offset function
You can correct the measured reading by a pre-defined offset value. The actual mea-
sured reading less the offset value is displayed.
Before you start
 The batch for which you want to make the changes is open in the gauge.
To activate the offset and set the offset value
1. > Batch Modify > OK > Offset > OK > On > OK > set desired offset value > OK
Parameter is activated:
2. Exit the menu: , the settings are now made.
The icon appears in the Measurement view to indicate the active offset func-
tion.
To deactivate the offset function
1. > Batch Modify > OK > Offset > OK > Off > OK
Parameter is deactivated:
2. Exit the menu: , the offset function is deactivated.
[ ]
[ ]
[ ]
O
[ ]