FISCHER FERITSCOPE DMP30 - Calling up Information about the Calibration

60
FERITSCOPE® DMP30
Calibration
9.5 Calling up information about the calibration
You can call up information for a selected calibration.
Before you start
 The probe containing the calibration whose information you want to view is
connected to the gauge.
 In the gauge is the batch open to which the calibration is assigned, whose in-
formation you want to view.
 If the calibration whose information you want to call up is locked, you need to
know the lock code.
To call up information about a calibration
1. Select the calibration whose information you want to call up: > Calibrations >
OK > select name of the calibration > OK.
2. Prompted to set the lock code?
- Yes: Set the lock code:
- No: Continue with step 3.
3. Open the information page: Info > OK.
4. Exit the information page: .
Description of parameters on page Info
Only the standards, with their values, that were used for the calibration are displayed
on the information page next to the date and time.
Std 1: 0.64 FN (example)
Indication of the nominal value for the Std. 1, used for this calibration.
Std 2: 2.7 FN (example)
Indication of the nominal value for the Std. 2, used for this calibration.
Std 3: 9.4 FN (example)
Indication of the nominal value for the Std. 3, used for this calibration.
Date / Time:
13.04.2022 10:23 (example): storage time of calibration
[ ]